Press the wireless enable/disable button to enable the wireless radio. If a wireless connection does still not exist, make sure that the wireless radio has not been disabled. Reboot process takes approximately 30 seconds. PDA – Use the PDA stylus to push the reset button located on the back side of the PDA. In most cases, the easiest way to re-establish a connection is to perform a cold boot of the ScreenLogic device:Ī. Make sure your wireless ScreenLogic device (PDA and/or Tablet) are connected to the ScreenLogic

If ScreenLogic has been previously working without a problem, try the following steps to resolve the problem:ġ.

If the Configuration program displays “Looking for controller,” for longer then 60 seconds when you start IntelliTouch ScreenLogic, this may indicate a communication problem somewhere in the system. Why does the Configuration program say “Looking for Controller”? Note: If you purchased a PDA, In-wall touch screen, or Tablet, a CD-ROM is also included that contains the ScreenLogic PC interface for your Windows XP computer. For Technical Support contact information, see page viii. Please consult your manufacturer documentation for other questions. Technical support for non-supported devices is not available. IntelliTouch ScreenLogic can only be used with the provided ScreenLogic PDA, Tablet, and in-wall Touch Screen devices. I can now once again make changes to all my pool functions from inside my home on either my PC or my phone.Use the following information to resolve general ScreenLogic operation issues.īefore contacting Pentair Water Technical Support, please note that Technical Support personnel can only assist with relevant questions regarding IntelliTouch ScreenLogic hardware and software. Same with the app which connected immediately after installing from the App Store. I downloaded the software from Pentair as per their provided instructions, installed it and within seconds was connected to my outdoor pool controller. Connected the cable to this protocol adapter which I then connected to the router with the provided ethernet cable. I simply re-routed the cable to the laundry where my Wifi router is located. I used the existing 4 conductor cable that was in place for my old Compool Indoor control panel. This is NOT correct and you ONLY need this protocol adapter. Pentair will advise you need to purchase this along the wireless adapter so as to utilize the PC software or the iPhone app. The Intellitouch Protocol Adapter is a very expensive item for what you get but it does exactly as advertised and seller was by far the cheapest found anywhere on the Web. Necessary item for remote connectivity but expensive.

Screenlogic interface wireless link